Problem s northbridge-om

Nisam siguran uopće treba li MC uopće imati dodijeljen IRQ, ne ćini mi se logično baš da treba. Često je BSoD uzrokovan problemima s memorijom, ali češće se radi o neispravnom modulu, dok crkavanje memorijskog kontrolera baš i nije svakodnevna pojava, pogotovo situacija u kojoj se uopće BIOS pokreće nakon toga. U kojoj ti se situaciji događa BSoD? Safe mode? Reinstalacija Windowsa?

to se meni događalo, al s nomrlanim temperaturama

tek nakon trećem downlclocka mi se sve popravilo

probaj par puta spustit, dignut pa spustit takt proca

nek ostane na defaultu

onda će sve radit...

matična šteka

bolja matična i sve će radit

(ja ponovo idem na 3.2 ghz..ima da sve radi ebem mu)

Analizirao sam memory dump BSOD-a i dobio sam poprilicno nerazumljiv tekst.(Skroz dolje)

Memtest je ok, osim ako stavim da testira sve adrese(addres range-bios, all) gdje se pojavi 5888 errora.

Temp:Proc- 40-45 c. Graf- 61-67 c. Northbridge- 70-75(sve idle)

*******************************************************************************
* *
* Bugcheck Analysis *
* *
*******************************************************************************

DRIVER_IRQL_NOT_LESS_OR_EQUAL (d1)
An attempt was made to access a pageable (or completely invalid) address at an
interrupt request level (IRQL) that is too high. This is usually
caused by drivers using improper addresses.
If kernel debugger is available get stack backtrace.
Arguments:
Arg1: e2251000, memory referenced
Arg2: 00000002, IRQL
Arg3: 00000000, value 0 = read operation, 1 = write operation
Arg4: f6ad5cf6, address which referenced memory

Debugging Details:
------------------


READ_ADDRESS: e2251000

CURRENT_IRQL: 2

FAULTING_IP:
+365952f0289dfdc
f6ad5cf6 ?? ???

DEFAULT_BUCKET_ID: DRIVER_FAULT

BUGCHECK_STR: 0xD1

TRAP_FRAME: f79e7cc0 -- (.trap 0xfffffffff79e7cc0)
ErrCode = 00000000
eax=00000000 ebx=f6ad87a0 ecx=0000011b edx=8001003b esi=e2251000 edi=805011fc
eip=f6ad5cf6 esp=f79e7d34 ebp=f79e7d44 iopl=0 nv up ei pl nz na pe nc
cs=0008 ss=0010 ds=0023 es=0023 fs=0030 gs=0000 efl=00010206
f6ad5cf6 ?? ???
Resetting default scope

LAST_CONTROL_TRANSFER: from f6ad5cf6 to 8053fa73

STACK_TEXT:  
f79e7cc0 f6ad5cf6 badb0d00 8001003b ff676980 nt!KiTrap0E+0x233
WARNING: Frame IP not in any known module. Following frames may be wrong.
f79e7d30 00000000 f6ad825c 0000011c e2251000 0xf6ad5cf6


STACK_COMMAND: kb

FOLLOWUP_IP:
nt!KiTrap0E+233
8053fa73 f7457000000200 test dword ptr [ebp+70h],20000h

SYMBOL_STACK_INDEX: 0

SYMBOL_NAME: nt!KiTrap0E+233

FOLLOWUP_NAME: MachineOwner

MODULE_NAME: nt

IMAGE_NAME: ntkrnlpa.exe

DEBUG_FLR_IMAGE_TIMESTAMP: 45e53f9c

FAILURE_BUCKET_ID: 0xD1_nt!KiTrap0E+233

BUCKET_ID: 0xD1_nt!KiTrap0E+233

Followup: MachineOwner

Doxy-iev savjet mi je pomogao, vise nema BSOD-a ili smrzavanja (za sad). :)

Ako se dobro sjećam, Prva strelica je DRIVER_IRQL_NOT_LESS_OR_EQUAL

A dva reda ispod druge strelice je samo STOP: 0x00000d1(jos nesto)

EDIT:Rjesenje je samo privremeno, sve je opet po starom. :(

Evo sad pisem iz safe moda jer 1.skeniram viruse i 2. Stalno mi dolazi BSOD bez obzira koliko ga downclockao(procesor).

Ispod STOP:0x000000d1(nesto) je Beggining pyshical memory dump i nista drugo.

Probat cu prvo skenirat viruse, a onda kupujem hladnjak za north. Osim ako netko nema neki bolji prijedlog?

Ok, reinstalirat cu Windowse cim nadjem cd.

Memtest je ok.
Temp:Proc- 40-45 c. Graf- 61-67 c. Northbridge- 70-75(sve idle)
Ventilatori svi čisti.

Ako možeš smanjiti,samanji na kojih 2400 rpm (trebalo bi biti dosta)

Ok.